File Permissions in Linux

Features : Ability to restrict or control the

Comments

Post a Comment

Popular posts from this blog

MRTG configurations

Setup the Device cisco(config)# snmp-server community public RO setup the MRTG server yum install   mrtg   -> will install the MRTG yum install httpd -> will install the apache to view the graphs crated by mrtg To configure the MRTG issue following command: Cfgmaker –global   “WorkDir: /var/www/mrtg” –output /etc/mrtg/mrtg.cfg   device-community - string @( hostname or IP ) in this command :             --global   “WorkDir: /var/www/mrtg”   -> this is global configuration to define where the graphs will be store - -output /etc/mrtg/mrtg.cfg    ->    this is the output file name   device community   string ->   Configured snmp name on the device. In this case it is ‘public’   as   configured under the cisco device hostname or IP  ->   device IP or hostname Now run the indexmaker...
Read more

T1 Link with VWIC-2MFT-T1

First insert the new VWIC card when router is power off. fix screws tightly Connect the T1 cable which is from the ISP side to the controller you want to configure power up the router log in to router using prefer method (telnet / console/etc) configure controller as follow MPLS(config)#controller T1 0/0 MPLS(config-controller)# framing esf MPLS(config-controller)# linecode b8zs  MPLS(config-controller)#channel-group 0 timeslots 1-24 speed 64 In here you have to calculate/inquire the speed before you configure the speed under channel-group. calculate is simple as follows   speed = bandwidth / number of channels if you configure controller then issue a sh run and see the virtual serial is appeared or not. if not you did not configure it correctly or your controller is not active ex: interface Serial0/0:0 then you can configure the serial interface according to ISP given settings after that you can issue sh ip interface brief command and see the interfa...
Read more

ADSL configuration on Cisco router

PPPoA   with   Cisco 1700+ WIC-1ADSL I have configured following with Cisco 1700 series router which includes  WIC-1ADSL Card. Please make sure the IOS is latest than 12.2 Configure ATM interface with the PVC number, DSL Mode , encapsulation and dialer pool interface ATM0   no ip address   no atm ilmi-keepalive   dsl operating-mode auto   pvc 0/38   encapsulation aal5mux ppp dialer   dialer pool-member 1 In here please check the dsl operating mode and encapsulation with your ISP. Most probably dsl operating mode   will works with auto. But you should   have to check the encapsulation   with ISP[aal5snap/ aal5mux]. BT(United Kingdom) use aal5mux. After that you have to configure the dialler interface with ADSL username and password accordingly PPPoA with Dynamic IP interface Dialer1   ip address negotiated   ip nat outside   encapsulation ppp   dialer pool 1 ...
Read more